bluelog Neo
bluelog Neo
Breadcrumbs

Status DI external

Last modified:

State inputs can be used, for example, by a "WAGO I/O System". This is necessary to be able to process alarms later via the digital input signals. Examples of DI external states include medium-voltage switchgear, UPS fault messages, and door contacts.

Add a DI external state

Prerequisites

  • The device is compatible with bluelog. See Compatibility check. If the type is not supported, contact Sales.

  • Your bluelog is connected to the network and the device has been physically connected.

  • The basic configuration of your bluelog has been completed. See Getting started.

  • All updates have been performed. See Update.

  • Add-on modules, if required, are connected. See Add-on modules.

Steps

  1. Go to Devices > Status DI external.

  2. Using the drop-down menus, select the Manufacturer (vendor) of the device you are scanning for. 

  3. Alternatively, using the drop-down menus, select the device type (Series) of the device.

  4. Select an interface. The interface settings will depend on the connection type. See the table “Interface abbreviations and meanings”.

  5. Adjust the interface settings. 

  6. To scan for a device, select Start scan. Select the Show details window to display the scan log.

The devices found appear under Installed devices. 

Interface settings

In most cases, interface settings can be found in the manufacturer documentation or the device itself.

If you do not know the bus address, activate the Use range toggle to scan the selected bus. To speed up the scanning process, select the smallest possible scan range:

  • RS485: Refer to the manufacturer documentation for baud rates and frame settings.

  • Ethernet: If possible, scan for either the IP address or client/slave ID, but not both.


Interface abbreviation

Meaning

BM

Base module

MX

MX module

DI

Digital input

MI

Multi input

DO

Digital output

e.g. MX-1: RS485-2 means the RS485-2 interface of the first connected MX module

Interface abbreviations and meanings

Note

During setup, the manufacturer's name is automatically assigned to a device. For better identification and organization, rename devices with a clear and distinct label. This improves chart readability and is particularly useful when managing multiple devices of the same type within your plant.

Example:

  • Default name: Meteocontrol Si-12TC BM: MI-1

  • More specific name: Irradiance sensor east 1

See our Naming guideline for more details.

Note

Beta drivers have not been tested in the field and may not be fully functional. If you encounter any issues, contact meteocontrol Support.

Note

If the signal of a status input does not correspond to the configured normal state, an alarm is triggered. Alarms are configured under Cockpit > Alarms/State > Alarm. The error description corresponds to the text in the Error message field.

Under Devices > Status DI external> Alarm/state column, select State to record signals without generating an active alarm notification.