bluelog Neo
bluelog Neo
Breadcrumbs

Safety

Last modified:

This chapter contains general safety regulations that must be followed during installation, operation, and maintenance of the bluelog. Failure to do so can result in injury or death and/or damage the bluelog. Read these safety regulations carefully before you start work on the bluelog. 

Intended use

Only the permitted signals and signal strengths may be applied to the connections of the data logger (bluelog) and the expansion modules (MX modules) used here.  

Installation is only permitted indoors. For installation outdoors or in a dusty environment, the device must be installed in a standardized protective enclosure. 

Notice

The following must be observed: 

  • All national installation and set-up regulations (e.g. VDE in Germany). 

  • The generally accepted codes of practice.

  • Information on transport, installation, operation, service, maintenance, and disposal given in this user manual.

  • Specific values, limits, and information relating to operating and ambient conditions on type plates and in data sheets. 

Personnel

Installation, commissioning, and maintenance of the device may only be performed by a qualified electrician.  

Given their specialist training, knowledge, experience, and familiarity with the relevant standards and regulations, a qualified electrician is in a position not only to carry out work on electrical systems but also to recognize and avoid possible dangers unaided. 

The qualified electrician must comply with the occupational health and safety laws in force. 

Protection concepts

  • The memory card must not be removed while the bluelog is in operation. 

  • The bluelog may not be opened. 

  • The bluelog may not be modified. 

  • Damaged devices must be taken out of operation immediately and checked by a qualified electrician. 

  • Local regulations must be observed when using the devices. 

  • The safety of the bluelog and the user cannot be guaranteed if the safety precautions described are violated. 

Internal battery

The bluelog contains an internal lithium battery (button cell), which ensures that the time and date remain stored in the device in the event that the power supply is interrupted. 

Notice

The housing may only be opened by qualified personnel.

  • The battery may only be replaced by the meteocontrol repair service, since the bluelog housing needs to be opened. 

  • meteocontrol GmbH accepts no liability for material damage owing to non-compliance with this warning notice!