Skip to main content
Skip table of contents

Safety

Last modified:

This chapter contains general safety regulations that must be followed when connecting devices to the blue’Log. Failure to do so can result in injury or death and/or damage the blue’Log and connected devices. Read these safety regulations carefully before you start work.

Intended use

Only the permitted signals and signal strengths may be applied to the connections of the data loggers and modules used here.

Installation is only permitted indoors. For installation outdoors or in a dusty environment, the device must be installed in a standardized protective enclosure.

Personnel

Installation, commissioning, and maintenance of the device may only be performed by a qualified electrician.

Given their specialist training, knowledge, experience and familiarity with the relevant standards and regulations, a qualified electrician is in a position not only to carry out work on electrical systems but also to recognize and avoid possible dangers unaided.

The qualified electrician must comply with the occupational health and safety laws in force.

Note

Please take into consideration:

  • All national installation and set-up regulations (e.g. VDE in Germany)

  • All generally accepted codes of practice

  • Information on transport, installation, operation, service, maintenance, and disposal given in the documentation for the devices used

  • Specific values, limits and information relating to operating and ambient conditions on type plates and in data sheets

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close