Discontinued products
English German
English German

WEB'log - Time synchronization

Last modified:

This page describes step-by-step instructions for setting or synchronizing the time on your WEB'Log.

Set the time on the WEB'Log

Prerequisites

  • You have local access to the WEB'Log.

  • The computer and the WEB'Log are on the same network.

  • The time server is accessible from the WEB'Log.

Steps

  1. Check the IP address on the WEB'Log. If you do not know the data logger’s current IP address, you can read it directly from the WEB'Log’s display:

    • Press the Enter key twice on the WEB'Log.

    • Enter the menu PIN 0020.

    • Navigate to the following menu item: Overview > Network > Current IP Address.

    • Write down the IP address displayed.

  2. Connect to the Web interface:

    • Connect a computer to the same network as the WEB'Log.

    • Open a web browser.

    • Enter the IP address of the WEB'Log (which you determined earlier) into the browser's address bar.

    • This will open the data logger's local web interface.

  3. Open time synchronization:

    • In the web interface, navigate to the following menu: Admin Measurement > Time Synchronization.

  4. Configure automatic time synchronization:

    • In the Automatic time synchronization section, select Performed daily at.

    • Then select the desired time at which the daily time synchronization should take place.

  5. Check the time server configuration:

  6. Check the time zone:

    • For Germany, for example, you can use the following selection: GMT +01:00 Amsterdam, Berlin, Madrid.

  7. Save settings:

    • Click Save on the right side to apply the settings.

  8. Trigger time synchronization manually:

    • In the Trigger time synchronization section at the bottom, click the Start button to initiate synchronization.

Next, check the system time displayed in the lower-right corner of the web interface. Verify whether the date and time were applied correctly.