Status DI internal

Both states and alarm inputs can be configured under Devices > Status DI internal. For this purpose, multi-input inputs or digital inputs are used via the blue'Log or the MX I/O modules. Examples of DI internal states include medium-voltage switchgear, UPS fault messages, and door contacts.

Add a new DI internal state

Prerequisites

The device is compatible with blue'Log. See Compatibility check. If the type is not supported, contact Sales.
Your blue'Log is connected to the network and the device has been physically connected.
The basic configuration of your blue'Log has been completed. See Getting started.
All blue'Log updates have been performed. See Update.
Add-on modules, if required, are connected. See Add-oon modules.

Steps

Go to Devices > Status DI internal.
Select the Plus icon.
Give the DI internal state a name.
Select the interface. The interface settings will depend on the connection type. See the table below for explanations of the abbreviations.
Select the normal state: open or closed.
Select whether the input is an alarm or a state.
Select the Save icon to save the settings.

Interface Abbreviation	Meaning
BM	Base module
MX	MX module
MI	Multi-input
DO	Digital output
e.g. MX-1: RS485-2 means RS485-2 interface of the first connected MX module

Table: Interface abbreviations and meanings

Info

If the signal of a status input does not correspond to the configured normal state, an alarm is triggered. To configure alarms, go to Cockpit > Alarms/State > Alarm. The error description corresponds to the text in the Error message field. With the option State only, the signals are recorded. You will not receive any active notification of the alarm.