Skip to main content
Skip table of contents

Active power (without HEMS)

Under Power control > Active power, you can configure parameters related to active power control. Here is a general overview of the user interface:

Active power (part1) without HEMS.png
Active power (part2) without HEMS.png

Active power overview

Item

Name

Details

1

Active power control toggle

Activate the toggle ONLY after you have fully configured your power control setup

2

Basic settings

In this area, you can select closed-loop or open-loop operation mode, and set a command method

3

Extended settings icon

Extended controller parameters / active power control for PV system, including the controller sampling time (default value: 500 ms)

4

Operation mode

See Closed loop vs open loop control (without HEMS)

5

Method switch

Toggle activated: Select from a method switch via digital input and method switch via Modbus and enter additional parameters

Toggle deactivated: Use the setpoint command method

6

Gear icon

Select relevant parameters from the dropdown for the setpoint command method and enter the values by clicking on the Gear icon

7

Fail-safe operation

Configure fail-safe behavior in case of communication loss. See Fallback behavior

8

Options

Configure ramp rate limiter. See Ramp rate limiter

9

Extended settings icon

Extended controller parameters for frequency-dependent control

For information about remote power control (without HEMS), see Remote power control (without HEMS).






JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.