.png){kind=logo}
Active power (without Hybrid EMS)
Last modified:
Under Power control > Active power, you can configure parameters related to active power control. Here is a general overview of the user interface:
%20without%20HEMS.png?inst-v=fc3f5cb6-8759-4b74-9926-e7f2f90fd165)
%20without%20HEMS.png?inst-v=fc3f5cb6-8759-4b74-9926-e7f2f90fd165)
Active power overview
Item | Name | Details |
|---|---|---|
1 | Active power control toggle | Activate the toggle ONLY after you have fully configured your power control setup |
2 | Basic settings | In this area, you can select closed-loop or open-loop operation mode, and set a command method |
3 | Extended settings icon | Extended controller parameters / active power control for PV system, including the controller sampling time (default value: 500 ms) |
4 | Operation mode | |
5 | Method switch | Toggle activated: Select from a method switch via digital input and method switch via Modbus and enter additional parameters Toggle deactivated: Use the setpoint command method |
6 | Gear icon | Select relevant parameters from the dropdown for the setpoint command method and enter the values by clicking on the Gear icon |
7 | Fail-safe operation | Configure fail-safe behavior in case of communication loss. See Fallback behavior |
8 | Options | Configure ramp rate limiter. See Ramp rate limiter |
9 | Extended settings icon | Extended controller parameters for frequency-dependent control |
For information about remote power control (without Hybrid EMS), see Remote power control (without Hybrid EMS).